Cycling Questions and Answers
Are bmx bikes obedient for commuting?
Question:I was wondering...if I bought a bmx
I might cram some simple tricks but...
I'll probably only use it for transport resembling..going to school or somthing
would a bmx bike be fitting for this?
also...would a mountain bike be good for commuting
Answers:
Depends on your route and (perhaps) where on earth you can keep it once you conquer your destination.
A BMX is a small-wheel, cramped riding position type of machine. For longer commutes, you'd any have to travel standing up, or suffering through an awkward cramped position for pedalling. It would bring more effort to product the trip as well, due to the gearing (or drought of it).
A mountain bike would offer better riding position and better effort-to-pedal value. The larger wheels would assistance for longer distances too.
However, the mountain bike may stand out more in the crowd of machines at your pause destination, which might make it a bit more feasible to be 'borrowed' and not returned to you, if you get my drift. The same could be true of the BMX, but is somewhat smaller amount likely (if everyone is already using mountain bikes, they're not feasible to steal a BMX!).
One more added advantage of the mountain bike is that YOU are more perceptible to automotive traffic, because you are more upright and complex off the ground. This is not an insignificant consideration when you're riding within an urban environment, particularly during morning or afternoon rush hour. Better to be past the worst, in my judgment - which means obey the rules and making sure the drivers can see you!
Lastly - with the larger wheel, it's easier to find a rack you can attach to the frame/axle to carry your stuff, instead of backpacking it adjectives over the place. This can be advantageous, especially if you're hauling heavy textbook or other 'gear' (musical instruments, sports equipment, extra clothing, etc).
It all depends on your commute. If you are planning on going for a few blocks next you surely can use a BMX. If your commute is longer, the low frame of the BMX may be hard on your knees. Also the small diameter of the tires will not allow you to be in motion too fast. Also if you stop pedaling, the bike stops moving unlike mountain or street bikes.
A mountain bike will be adjectives to commute if you have un-even surfaces to ride on. If you individual bike on a paved road for a long distance, a road bike will be the best.
I use my bmx bike for commuting adjectives the time. Since there are no gears its a actual workout but I think its greatly more fun to ride than any other bike.
Yeah a mountain bike would be fine, but id prefer the bmx bike.
FYI: The character who said "Also if you stop pedaling, the bike stops moving unlike mountain or street bikes." <--Not true! BMX bikes have bearing that let you stop pedaling
If you are comfortable near in and savour riding a BMX bike distance, go for it. I will relate you thought that most commuters would not like it. They own smaller wheels which are more inefficient and do not hold an extended position for a good spin.
I'd choose a mountain bike over a bmx, consequently put smoother road tires on the bike.
Hey! Do what I did! Get a Dirt Jumper! You will have the best of both worlds. A Dirt Jumper is a Hardtail Mountain bike near a beefed up frame and near usually a 4 to 6 inch travel front fork. These bikes are used for dirt jumping single and doubles resembling the BMX bikes. I use my bike for Commuting, Urban Assault, Dirt Jumping and Mountian Biking. They are heavier than the standard mountian bike because they are just beefier contained by all the crucial areas of the frame and the unhealthy oil/coil single crown freeride forks that are used. One of my friends even put a Gyro on his headset for 360 bar spins. Just my 2 cents. Hope this help!
"Also if you stop pedaling, the bike stops moving unlike mountain or street bikes." yeah that doesnt happen bmx bikes can roll pretty far due to the street tires and bearing. i have rode my bmx from cambridge to kitchener heaps times(about an hour ride) and have have no problems.
This is a bicycling put somebody through the mill just about protecting the knees.?
Question:When cycling, is it good to extend the form post to the max so that the down stroke fully extends the leg with no "bend". Or is it better to own more "bend" on the legs so as not to strain the knees.
Answers:
For the perfect "bike fit" do this:
1. Raise your form so you can comfortably extend your legs to the pedals.
2. With your heal on the middle of the pedal, and the pedal within the lowest position (6 o'clock), your leg should be fully extended with your knees locked.
3. Now put the orb of your foot on the center of the pedal as it is still in the lowest most position. Your knees should have a slight bend.
4. To check your "fore & aft" position, hold a friend hold your bicycle and put your pedals in the 3 and 9 o'clock positions or parallel to the ground. Have your friend sway a string with a washer tied to the back of it (plum bob) from the front of your knee panama. The washer should be touching the end of the crank arm. If it is furhter away or down it, adjust the position of your seat as expected.
5. If you still have knees pain, move about to your local bike shop and have them fit you professionally.
hope this help!
During cyciling u want to almost fully extent your legs so u want to have fundamentally little bend in your leg
agree near bikedude7
There should only be a slight bend at the bottom stroke. Too low and it can hurt your knees. Too soaring, your hips...
How much does a trek y-33 mountain bike weigh?
Answers:
That's a very difficult cross-question without more information. It really depends on the approach that your bike is configured. Different component levels on the bike are going to fine-tuning the weight, along near any options that you donate. Off the shelf, this bike can weigh in the 22 lb list. Adding water bottles, full, can supply up to 5 lbs each; accumulation a saddle bag beside components (tube, levers, co2, pump, etc.) can give another 3 lbs.
How on earth can you possibly see in your mind`s eye that someone here has that sort of information to appendage. Why don't you ask a supplier.
Do shimano dura ace brake pad fit onto shimano ultegra calipars?
Answers:
It depends on the year/model of the pads, and the year/model of the calipers, if you're conversation about a short time ago the pads.
If you're discussion about the pad and the holders, then you shouldn't hold a problem.
yes they do. I used to own a bike with ultegras and at the time the merely replacements I could get be Dura-Ace, and they fitted fine!
not always, what yr is it?
I'd read out stick to the group set if you're not sure. Can't be wrong if you do.
Resolved Questions