Cycling Questions and Answers
How do you modify a bicycle tire?
Question:I have a road bike.
Answers:
Here's the straight dope from Park Tools:
http://www.parktool.com/repair/readhowto...
It's one of life's little joy changing a tire.
front is straightforward -- lossen the brakes, then loosen the tire and adaptation it.
back -- loosen the brakes and the fasten. make sure the flipside gears are similar to what you had beforehand (# and spacing) and do the same as the front. i've never deal with the gears contained by the back but .. [the concluding rear tiller that i personally changed be on a 5-speed bike i used to deliver papers on my paper route roughly 30 years ago.]
I think the give somebody the third degree asked is - what type of tools or procedures do you use to get the investigational tube and the tire back onto the rim. This is where on earth most people be in motion bad on a conversion. Here is a hint, don't use anything sharp to pry that tire over the tube. Bike shops grant blunt pry tools to do this. My changed tire never lasts as long as the unproved. I think I am getting the tube folded underneath the tire or something.
How much does a Yamaha deluxe surf runner 110 cost at 2 years ripened?
Question:it has 3 years on warreany an 57 hours ride time
Answers:
Try Kelly blue book online. Your local Yamaha contractor could also give you this info.
This is cycling, Please this doesn't belong here. There's an Outdoor Recreation forum for this.
Look to the gone side of your screen where on earth it says CYCLING, presently go down, no down further, ancient OUTDOOR RECREATION.
Just a little farther, you can do it...
DON'T GET DISTRACTED BY THE PRETTY COLORS!
There it is! The category you REALLY want: WATER SPORTS!
Now try this interview again.
Good Luck
Is it possible to fit a hollowtech bottom bracket and crank to a bike yourself?
Answers:
Yes all you need is the proper Shimano tool and you are off to the races. Check your local bike shop out for the tool.
I hold a 1997 lemond road bike. I would resembling to know if here is a carbon fork replacement pick.?
Answers:
Assuming your Lemond has a 1" quilled stem, I just this minute did a similar conversion myself.
Obviously, you'll need the following:
Carbon fork beside 1 inch threadless steerer.
1" threadless stem, or 1 1/8th" threadless stem with a shim
1" threadless headset
You may know how to get away near using your old handlebar, but it might be a moral time to look into a replacement.
Since threaded forks and quilled stems are so rare very soon, and the conversion to threadless is so easy, there's no function not to do it.
There are many option. As it is a 97, you will need a fork beside a 1" steerer tube. Check Nashbar or Performance for their offerings. If this is a warranty question, email Trek. They may hold a lifetime warranty for the original owner.
Yes, You hold many option, stay as far away from Supergo, Performance and sporting goods stores as possible, they are under the weather equipped to deal beside upgrades of any type. support a local Independent Bicycle Dealer(IBD) they will take their time, do it right and probably ask you to turn for a ride next sunday. It might cost 2-5 dollars more but you'll hold a friend who wants you to come wager on. and you'll be able to serve support your local economy.
Resolved Questions